© Copyright 2020 BriskSale, LLC. All Rights Reserved.
|Category||Electronics / Computers Tablets Networking|
|Shipping||$76.9 ($38.45 each additional item)|
|Expiring On||Nov 10, 2018|
Tripp Lite UPS SMART2200RM2UN 2U SmartPro 2.2kVA Line Interactive 1920W RetailTripp Lite SmartPro Line Interactive UPS with enhanced LCD interface offers network-grade power protection for critical server, network and telecommunications equipment. Line Interactive Uninterruptible Power Supply (UPS) with built-in Auto-Voltage Regulation (AVR) actively corrects brownouts and overvoltages back to usable levels while maintaining a full battery charge in case of power failure. Tripp Lites unique configuration excels in exceptionally poor-power environments with two separate levels of voltage boost to correct both slight undervoltages and severe brownout conditions. Interactive LCD interface reports UPS operating mode, detailed UPS and site-power data, plus enables a variety of UPS setup and configuration options. Super-fast switchover from line to battery power occurs within milliseconds to maintain operation of connected equipment without interruption or reboot. 96% line-mode efficiency offers reduced heat emissions and operating costs. Network management interfaces support communications via USB, RS-232 and Pre-installed SNMPWEBCARD network interface. HID-compliant USB interface enables integration with built-in power management and auto shutdown features of Windows and Mac OS X. Network communications ports enable detailed monitoring of equipment load levels, self-test data and utility power conditions. Includes PowerAlert monitoring software and complete cabling. Switched output load banks enable scheduled and real-time remote reboot and load shedding of select outlets. Emergency Power Off (EPO) interface. LCD display panel easily rotates for viewing in rackmount or tower configurations. Audible alarm with push-button momentary alarm-cancel and silent-mode configuration options. Programmable self-test. Field-replaceable, hot-swappable battery modules. OUTPUTOutput Volt Amp Capacity (VA):2200Output kVA capacity (kVA):2.2Output Watt Capacity (watts):1920Output kW capacity:1.92Output power factor:0.87Nominal Output Voltage(s) Supported:120VFrequency compatibility:60 HzOutput voltage regulation (Battery mode):+/- 5%Built-in UPS output receptacles:4 5-15R outlet(s) 4 5-15/20R outlet(s) Built-in controllable switched load banks:Two switchable single-outlet load banksOutput AC waveform (AC mode):Pure Sine wave INPUTRated input current (at maximum load):16A (120V) Nominal Input Voltage(s) Supported:120V ACUPS input connection type:5-20PInput circuit breaker:20AUPS Input cord length (ft.):10UPS Input cord length (m):3 BATTERYFull load runtime (minutes):4.5 min. (1920w) Half load runtime (minutes):12 min. (960w) DC system voltage (VDC):48Battery recharge rate (included batteries):Less than 4.5 hours from 10% to 90%Replacement battery cartridg VOLTAGE REGULATIONVoltage regulation description:Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 83 to 145Overvoltage correction:Input voltages between 127 and 145 are reduced by 12% LEDS ALARMS and SWITCHESFront panel LCD display:Front panel LCD information and configuration screen offers detailed UPS and site power status and operating data, plus configuration of voltage, operating mode, alarm function and a variety of aAlarm cancel operation:Power-fail alarm can be temporarily silenced using alarm-cancel switch silent mode alarm configuration option availableSwitches:3 pushbutton switches control OFF / ON power status, MODE selection and MUTE / ENTER control functio SURGE / NOISE SUPPRESSIONUPS AC suppression joule rating:570UPS AC suppression response time:InstantaneousEMI / RFI AC noise suppression:Yes Installation form factors supported with included accessories4 post 19 inch Installation form factors supported with optional accessories2 post rackmount (2POSTRMKITWM) Wallmount (2POSTRMKITWM) Tower (2-9USTAND) Primary form factor Installed whole system total rack space height Secondary form factorTower (requires 2-9USTAND) UPS housing material Cooling method COMMUNICATIONSCommunications interface:USB (HID enabled) DB9 Serial EPO (emergency power off) Slot for SNMP/Web interfaceNetwork monitoring port description:Pre-installed SNMPWEBCARD interface Supports detailed monitoring of UPS and site p LINE / BATTERY TRANSFERTransfer time:5 milliseconds (AC to battery mode), 1 millisecond (Battery to AC mode) Low voltage transfer to battery power (setpoint):83High voltage transfer to battery power (setpoint):145 SPECIAL FEATURESGrounding lug:Back panel grounding lugCold Start (startup in battery mode during a power failure):Cold-start operation supportedHigh availability UPS features:Hot swappable batteriesGreen and high efficiency feature Item Dimension (LxWxH): 7.87 x 21.65 x 24.21 68.71 lb Warranty Information: 2-year warranty, 3 years with registration
|Policy||You can return your purchase for up to 30 days, There will be a 20% restocking fee on unwanted items.|
|Return Shipping is paid by||BUYER|